When Wireshark was previously launched it was named Ethereal. It is used for network troubleshooting, software communication protocol development. Comments are welcomed below.Wireshark and Nmap is a free and open-source project used as a network packet analyzer tool, it is used to capture packets over a network and analyze it. I hope you find this article and its content helpful. sudo usermod -aG wireshark $(theusername)įinally, restart your Ubuntu system to make the necessary changes to your system. Use the usermod command to add yourself to the wireshark group. Since you have allowed the non-superuser to capture packets, you have to add the user to wireshark group. On the screen that pops up, select Yes by pressing the tab key and then using enter key. If you want to run Wireshark without sudo (for instance if you selected No in the previous installation), then run the following command as root: sudo dpkg-reconfigure wireshark-common Select Yes to allow and No to restrict non-superusers to capture packets & finish the installation. Your Wireshark will be updated to the newer stable version.ĭuring the installation process, you may be asked whether to allow non-superusers to capture packets. Sudo apt-get install software-properties-common
**Note here: if any of my readers are Kali Linux people - the above should work, but I noted in the latest version of Kali, you must also run this command: In a terminal, use the following commands one by one: sudo add-apt-repository ppa:wireshark-dev/stable If not having the latest release is an issue for you, you should add the official Wireshark PPA.
You can always show which version of Wireshark you have with this command: apt show wireshark Sometimes, when you install Wireshark in the manner described, or you install Ubuntu Linux as a new system, a VM, or whatever, you will note that the version of Wireshark is older than the current release, so this getting the atest release can be an issue if the repositories are not updated (and trust me they are painfully slow). Perhaps you need to add the repository first: sudo add-apt-repository universe Just add it from the software installer, or from the terminal/command line: sudo apt install wireshark Installing Wireshark in Ubuntu or virtually any Linux distribution is pretty easy - it is available in almost all Linux repositories. I know I have put the answer to this in other articles over the years ( like this one), but I think it is appropriate to answer the question directly and specifically. 5 of 5 - 9 votes Thank you for rating this article.įirst things first - the Wireshark downloads page is here:
0 kommentar(er)
